I seem to have bricked the pedal

OWL
#1

So, I got it home, plugged it in. Played for 10 minutes then plugged it into the computer to see if I could add more effects, but got nothing. I then plugged it back into the amp, but nothing happened, not even the LED light.

I’ve attempted to follow the instruction here: http://hoxtonowl.com/wiki/Hardware_DFU but I’m certain I’m missing something. I have taken the back off, moved the pin, and then attempted to upload the master firmware bin from github using owlnest, but once the process seems to finish, the LED flashes red for a second then nothing, no change.

Please help!

#2

Don’t panic!

First, move the pin jumper back to the previous (non-DFU) position. Power cycle while holding down the LED pushbutton. The LED should flash red three times. If it does, you know the bootloader is working.

Power cycle again to boot the pedal normally. Pressing the pushbutton should now toggle the LED between red and green. If it does, the firmware is working and you’re good to go.

If either of these does not work let us know and we’ll guide you through the process!

#3

hey mate, thanks for your help!

Nah neither of the steps worked. I await further instructions.

Edit: dw mate, I figured it out. Just needed a few beers :slight_smile: